18
GB
Battipav srl
TECHNICAL DATA
Voltage:
230V 50/60Hz.~
Power: 550W
Admissible working conditions:
INTERMITTENT - S6-25% SERVICE
30 s under load running
90 s loadless functioningt
Rotation speed:
2800/3400 min-1
Condenser:
8 µF
Capacitor:
5 l
Tool:
CONTINUOUS CROWN DIAMOND BLADE WET
CUTTING
Recommended use:
CERAMIC, SINGLE-FIRED CERAMIC, COTTO AND
MARBLE (max. thickness 1-1.5 cm)
Sound:
LOADLESS VALUES
Lw
69,2 [dBW(A)] 0,0 [mW(A)]
Lw
100,2 [dBW(A)] 14,3 [mW(A)]
UNDER LOAD VALUES
Lpm
62,7 [dB(A)] 62,7 [dB(C)max]
Lpm
92,0 [dB(A)] 100,7 [dB(C)max]
The noise emitted by this machine was measured on
production samples in compliance with ISO 3745-77
standards.
The machine was positioned on an H800 (mm)
auxiliary table.
The samples comprised 314x314x8 mm single-fired
tiles, mod. P3T287 1200°C. K = 2, \[ dB ], pr EN 848 - 1
INSTALLATION
POSITIONING
Remove the machine from the packaging and check
that no parts have been damaged.
Place the machine on a stable surface free of other
material.
CAUTION
3
Position the blade guard approximately half a
centimetre above the tile surface through the
knob.
Lock the blade guard in position by fully
tightening the screw illustrated in the figure.
CHECKING BEFORE USE
CAUTION
THE MACHINE MOD. 718 HAS BEEN DESIGNED
FOR WORKING EXCLUSIVELY WITH WATER.
4
Before and during cutting operations, make
sure that the water level is the same as the one
indicated in the relevant label located on the
machine side.
Fill or top up the basin directly, as shown in the
figure.
CAUTION
In particular cases, it may be necessary to use a
basin to recover the cooling water.
If so, it is recommended to use a basin with the
following dimensions:
L 50 cm, P 60 cm, H 10 cm
BLADE ASSEMBLY / DISASSEMBLY
Remove the blade guard.
5
Use the 4 mm. Allen wrench to hold the motor
shaft.
Unscrew the blade flange block nut with the 19
mm wrench.
Summary of Contents for MAGIK
Page 3: ......
Page 4: ......
Page 7: ...7 Battipav srl Battipav srl 3 4 5 1 2 1 5m 1 5m 1 5m 6 7 8...
Page 43: ......
