Andromeda MAX VAP mod.2009 v1.1
pag. 8
gennaio 2009
1.
Use only tap water.
2.
Never add additives to water.
3.
Empty the boiler once a week, making sure that boiler pressure is not
over 0,5 BAR
(fig. 1: manometer).
To carry
out this operation, turn the exhaust
tap slowly: we advise you to wear gauntlets against possible burns.
N.B.
Carry out
this operation only when the boiler is cold and the plug is disconnected from the
mains.
4.
Never leave hot iron on ANDROMEDA MAX VAP ironing board.
5.
Connect ANDROMEDA to a suitable and protected outlet.
6.
After ironing is over, switch ANDROMEDA MAX VAP off and turn the water tap off;
always remember to turn the water tap on before switching on the machine again
(only for ANDROMEDA MAX VAP connected to the aqueduct).
7.
Always keep children away from ANDROMEDA MAX VAP, both when it is on and off.
8.
Make sure that during cold season the tubes connecting ANDROMEDA MAX VAP to
the water supply do not freeze.
9.
If the machine is not used for a long period of time, turn it off by using the main
switch.
13.
IRONING
1.
Run the iron on the garments, pressing the micro-switch
(fig. 4)
at regular
intervals and at the same time pressing the pedal for vacuum
(fig. 1)
. In order to
dry the garments, we suggest to keep the foot on the pedal for vacuum a bit
longer.
2.
For delicate, black and blue garments, we suggest to use an anti-sheen shoe.
3.
During ironing operation, always put the iron on its iron rest and pay attention to
the position of the cables: if they twine or get in touch with the ironing board, they
might cause short circuits.
4.
For dry ironing it is possible to adjust the thermostat
(fig. 3)
on different positions
according to the type of fabric (check garment label).
5.
For steam ironing you should adjust the thermostat on “cotton” position
(fig. 3)
(suitable for all types of fabrics).
6.
ANDROMEDA MAX VAP is equipped with a pedal for steaming on ironing board
(fig.1). This pedal is needed to provide steam to the ironing board and is used
mainly for knitwear. Once the pedal for steaming has been pressed, immediately
use the pedal for vacuum to dry the humid garment. A pedal for blowing is also
available for those garments which require blowing.
N.B
. If steaming is used very
often, some water may come out of the air outlet of the motor. It is therefore
necessary to connect it to an air outlet pipe. N.B. Upon steaming, set the
temperature of the ironing board at 120°C.
7.
ANDROMEDA MAX VAP is equipped with an air deviation (fig. 1) which may be
closed, thus increasing the vacuum power on the sleeve ironing arm.
Fig. 4
Fig. 3
ELECTRICAL
WIRE
THERMOSTAT
MICROSWITCH
FOR IRON
STEAM HOSE
