Era mod. 2010 (v. 2.0)
4
2019
5.
Fix the cable support in the specific hole (fig. 1-M), connect the iron plug to the
socket (fig. 1-O) and fix the steam hose to the solenoid valve with a hose clamp
(fig. 1-P).
6.
Fix the iron cables to the cable support hook (fig. 1-A), paying attention to avoid
twisting.
7.
Place the iron on the rubber iron rest (fig. 1-N).
4.
WATER CONNECTION
Connect the machine to the aqueduct. The water pressure must not exceed 2,5 BAR
otherwise the pump get stuck and so also the water entrance.
For connection, check that there is a tap nearby and a rubber hose that resists the
aqueduct pressure. The rubber hose must be inserted and fixed onto the “WATER
INLET HOSE-HOLDER” of the machine - diameter 10 mm (fig. 1-U) by using two hose
clamps.
Note:
before connecting the machine to the aqueduct, discharge a few liters of water
to clean the system pipes.
If a water connection is not possible and the machine requires a water tank,
ask the manufacturer or dealer about the changes to be made.
It is recommended to use only drinking water. Do not use distilled water or with a
hardness less than 12°f, as this type of water causes malfunctions in the machine
(corrosion, dark water from the iron, etc. …).
If the water is excessively hard (more than 20° f) it is recommended to install a water
softener that reduces dissolved salts in water.
Once ironing is finished, close the water tap and remember to open it before turning
on the machine.
Caution:
do not use the machine with the water tap closed otherwise the pump would
be irreparably damaged.
5.
ELECTRICAL CONNECTION
Connect the machine to a protected socket with earth protector switch, with
observance of the law in force and a voltage suitable to the ironing board.
Be sure the voltage and power frequency correspond to what is written on the label
placed on the machine.
It is compulsory to connect the equipment to a good ground wire and the connection
has to be done by qualified personnel.
The machine is supplied with electric cable. Match the colours above to connect the
machine cable to the electrical system/plug.
