Era mod. 2010 (v. 2.0)
5
2019
NEUTRAL
BLUE
PHASE L1
BROWN
PHASE L2
GREY
PHASE L3
BLACK
GROUND
YELLOW/GREEN
6.
ELECTRONIC CARD OPERATION: “STANDARD” & “STAND-BY” MODE
By turning on the main switch, the machine is in
“stand-by”
mode (red led on). This
mode allows access to the SET menu in order to set functions (e.g.: language,
periodical maintenance warnings etc. – see chapter SET MENU).
Electronic card in
stand-by
mode
. If maintenance should be required the
following warning
“MAINTENANCE SUGGESTED”
or
“SERVICE NEEDED”
will appear on the display.
The warning will disappear once the reset procedure has been done.
By pressing the green start key, the machine is in standard
mode. This allows to set
the ironing functions (e.g.: temperature of ironing board, speed of vacuum-blowing
motors, iron functioning etc…).
Start key. Electronic card in
standard mode.
To temporarily turn off the machine you may press the start key: the machine will go
into stand-by mode and the red led will turn on. However, the electronic card will
continue to receive power from the mains supply.
At the end of each working day we suggest to always turn the machine off by
using the main switch (fig. 1-I).
7.
USE OF KEYS
°C
UP
DOWN
“Ironing board temperature” increase and decrease keys
.
Adjustable
from
0° C to 90° C (or from 0° C to 120° C on steaming models).
Upon pressing one of the keys, the set temperature will be displayed
(
IRONING BOARD TEMP. SETTING
). If no key is not pressed after 5
seconds, the real temperature of the ironing board will be displayed
(“
IRONING BOARD TEMPERATURE”
).
WITHIN THE MENU: it allows to scroll through the different settings.
