Gea V.06
6
2018
8.
STANDARD OPERATION
1.
Make sure that the master switch
I/O
placed on the rear side of the machine is in
position
I
.
2.
The green indicator lights up on the control panel, indicating that the machine is
ready for use. The message
“
INSERT ITEMS AND CLOSE THE DOOR
”
appears
on the display.
3.
Insert the items to be sanitized and cleaned inside the machine, making sure to
place them as far apart as possible.
For a higher performance it is recommended not to store folded or overlapping
items.
N.B.:
the items to be sanitized must not be wet.
4.
Close the cabinet door, making sure that the knob is safely closed.
5.
When the door is closed, the message
“
SELECT PROGRAM
”
appears on the
display.
Then select one of the three available programs, the one you prefer, by
pressing the corresponding button.
The three sanitizing programs are preset at the factory to obtain the optimal
performance of the machine.
Program 1 - SHORT 30 minutes:
suitable when there are few items inside the
cabinet or items that are not particularly malodorous.
Program 2 - MEDIUM 35 minutes:
suitable for a medium load of clothes inside
the cabinet.
Program 3 - LONG 40 minutes:
suitable when you want to perform a strong
hygienic action or when there are many particularly malodorous garments or items
in the cabinet.
6.
Once the program has been selected, the green light turns off and indicates that
the cabinet is busy and is running the sanitizing program. The message
“
PROGRAM IN PROGRESS
”
appears on the display.
The remaining time to finish
the sanitizing process is also displayed.
The button for the selected program remains lit.
7.
At the end of the program the machine will emit an intermittent sound for a few
seconds to alert the operator that the cycle is finished and the door can be opened.
The green light is on and signals that the machine is free for a new sanitizing
cycle.
The message
“PROGRAM COMPLETED–
<OPEN THE DOOR>”
appears on the
display.
The message will stay on the display until the cabinet door is opened.
8.
Open the door and proceed to remove the items from the machine.
9.
SELF OPERATION WITH CENTRALIZED COIN MECHANISM/BUILT-IN COIN
MECHANISM
1.
Make sure that the master switch
I/O
placed on the rear side of the machine is in
position
I
.
2.
The green indicator lights up on the control panel indicating that the machine is
ready for use. The message
“
INSERT CREDIT
”
appears on the display.
3.
Insert sufficient credit to start the program in the centralized coin mechanism or in
the built-in coin mechanism. The 3 programs have a different cost so, every time
the credit needed to start the program is reached, the corresponding button lights
Summary of Contents for GEA
Page 17: ...Gea V 06 16 2018 26 ELECTRICAL DIAGRAM...
Page 18: ...Gea V 06 17 2018...
