Giove
5
2020
Place the device on a stable, flat and heat-resistant surface.
The machine can operate in two modes: steam mixed with sanitizer liquid or steam
only.
Make sure that the power cord plug is unplugged from the power outlet and the
appliance is off. Then proceed as follows:
USE OF STEAM WITH SANITIZER LIQUID MODE:
1. Insert a solution consisting of alcohol and water into the tank, with which surfaces
and clothing can be sanitized. It is recommended to use 70% alcohol and 30%
water (3 liters of water and 7 liters of alcohol), in order to obtain an excellent
sanitizing solution. It is recommended not to exceed the "MAX" level indication in
the tank and not to go below the "MIN" level indication.
(see chapter "SANITIZER LIQUID REFILL").
2. Unscrew the safety valve cap from the machine (fig. 3), fill the boiler only with the
desired amount of water. Screw the plug back on from the top, taking care not to
tighten it too much otherwise the gasket will be damaged (see chapter "BOILER
REFILL").
3. After filling the sanitizer liquid tank and the boiler, insert the plug into the socket.
4. Turn on the boiler switch (fig. 2 D).
N.B.: it is recommended not to exceed the
MAX indication in the level glass (fig. 1 I) and to pay attention that the
boiler discharge cock is closed (fig. 7).
5.
If the boiler is overfilled
beyond the MAX indication in the level glass, the gun,
brush or iron may release water or very humid steam. In this case, the appliance
must be switched off. Slightly unscrew the safety valve cap (one turn), wait for all
the steam inside the boiler to go out, wait for the water and the boiler to cool
completely then carefully open the drain cock and let the excess water drain out
(see the “
boiler discharge
” chapter).
6. Wait for the boiler light to go off (fig. 2 F); the pressure gauge must indicate
approximately 4 bar (fig. 2 E). At this point, press the micro-switch (fig. 4) 4-5
times, releasing the steam. You must also make sure that the steam is well
saturated. You can also adjust the desired amount of steam by turning the steam
adjustment knob located in the solenoid valve. Once the operation has been
completed, the machine is ready to be used. During use, the boiler light turns on
and off continuously, a sign of normal operation (fig. 2 F).
7.
To sanitize
by using the alcohol and water solution it is necessary to turn on the
tank switch (fig. 2 B); this way the sanitizer liquid is mixed with the steam and the
machine is ready to sanitize garments and / or surfaces.
USE OF STEAM ONLY MODE:
follow the operations from point 2 to point 6. Make
sure that the switch in fig. 2 B is in position 0 to deactivate the mixing of the sanitizer
liquid
with the steam. Only “pure” steam will come out of the accessories, without the
sanitizer liquid.
7.
GENERAL WARNINGS
1.
Avoid connecting the appliance to multiple sockets and / or extensions that are not
adequate for its power.
2. The device must be used and left to rest on a stable surface, in a closed
environment with a temperature b 10 ° C and + 40 ° C. Do not place t
he
machine outdoors or expose it to the action of atmospheric agents.
