Giove
10
2020
11.
CONNECTION OF ACCESSORIES
IMPORTANT:
Attach and unhook accessories with the machine turned off and cold in
order to avoid hand burns.
12.
BOILER REFILL
When you notice that the steam flow is significantly reduced and then ends
permanently, it means that there is no more water in the boiler. Total water depletion
is signaled by the light switching on (fig. 2 A).
At this point remove the plug from the socket, wait for the boiler to cool off and
unscrew the valve cap.
Warning:
if after slightly unscrewing the safety cap steam comes out, it means that
there is still pressure inside the boiler and you need to wait a little longer.
WARNING:
never fill the boiler as soon as the safety cap is opened and the boiler is
still hot, even if the plug is unplugged. The water in contact with the hot and empty
boiler evaporates instantly, causing a spray of steam that could cause skin burns.
Refill the boiler with water (fig. 5) taking care not to exceed the MAX mark. It is
advisable to fill the boiler with water using a funnel and in any case, when filling,
always keep your face away from the water inlet.
Screw the valve cap back on (fig. 3), reinsert the plug into the socket and wait until
the boiler light goes off (fig. 2 F).
Insert the plug of the accessory into the socket located on
the machine as shown in the photo on the left. Make sure the
plug is pushed in all the way.
To disconnect the plug, press the tab indicated by the arrow
and pull upwards.
Connect the steam coupling by inserting it into the
appropriate socket. Just press until you hear the "click" that
ensures correct connection.
To disconnect the steam coupling, grasp the knurled ring nut
and push it in the direction indicated by the arrow, in this
way the tube can be released.
