PLUTONE ’09 v01
pag. 2
marzo 2009
2.
IMPORTANT
Before installing PLUTONE, it is necessary to set up the following:
1.
a water connection (tap with hose holder); PLUTONE will be connected to the tap
with hose holder named “WATER INLET”
(fig. 1)
by means of a rubber hose which
must have a pressure resistance of at least 10 ATM. (diameter of water inlet 8/13
mm) and which must be fixed tightly with 2 hose clamps.
N.B.:
before inserting the
rubber hose into PLUTONE hose holder, exhaust a few litres of water in order to
clean the conduit.
ATTENTION:
PLUTONE equipped with water tank does not need
piping preparation;
2.
a protected electrical outlet suitable to PLUTONE power.
3.
OPENING OF PACKAGE
1.
Open the box containing PLUTONE from the upper side marked as ALTO , take
out the instructions handbook and read it carefully.
2.
Remove PLUTONE from the box, fix the cable support to the ironing board, connect
the iron and steam hose plugs
(fig. 1)
, fix the iron cables to the cable support
hook and place the iron on the iron rest
4.
STANDARD MODE
SET
Reset
Key to enter the menu and reset the various warnings.
“Pistol/brush” on/off key (optional accessory)
Esc
“Electronic card” on/off key. N.B.: the electronic board will continue to
receive power from the mains supply. At the end of each working day it is
suggested to always turn the machine off by using the main switch (fig.
1).
“Iron 1” on/off key
“Iron 2” on/off key
Ok
“Boiler” on/off key
