Prometeo – Prometeo soffiante
13
2016
order to avoid forming of stagnation on ironing board and allow the garment to
dry.
2.
For delicate, black or blue garments we suggest to use the specific anti-sheen
shoe.
3.
During ironing, always put the iron on its rubber rest (fig. 1).
4.
For dry ironing it is possible to adjust the thermostat (fig. 5) on various positions
according to the type of fabric (check garment label). For steam ironing, set the
t
hermostat on “cotton” or “
linen
”
7.
WATER FILLING
During the ironing, if steam flux decreases considerably and then ends completely, it
means that there is no more water in the boiler.
Unplug the machine, unscrew the safety valve plug just slightly 360° (fig. 4) so that
all the steam comes out. Once this has been done, carefully unscrew the safety valve
plug and wait for 5/10 minutes.
Fill the boiler up to the desired level paying attention not to overfill the water on it. It
is recommended to use a funnel. Screw the safety valve plug again (fig. 4), turn on
the machine and wait for the boiler lamp to switch off (fig. 4 F). Now the iron is ready
again.
While refilling the boiler, do not spill water onto the machine. In the event this should
happen, dry immediately in order to avoid electrical risks.
8.
BOILER DISCHARGE
Empty the boiler periodically. Carry out this operation when the ironing board mod.
PROMETEO is turned off, cold and unplugged. Wait at least 1 hour after the switching
off. During this procedure, wear proper gloves in order to avoid accidental burns.
Unscrew the safety valve plug and open the discharge tap (fig. 1), wait for all the
water to come out and then close the tap again. The tap might get clogged: in this
case use a wire with a diameter of 3-4 mm to unclog it.
ELECTRIC
WIRE
THERMOSTAT
MICROSWITCH
FOR IRON
STEAM
HOSE
Fig. 5
Fig. 6
