T250P
9
2016
6.
IRONING
The ironing board mod. T250P is equipped with two functions: vacuum and blowing.
Both functions can be activated by pressing the specific pedal.
The vacuum of the board helps to keep the garments stretched and eliminates any
humidity making the ironing easier and faster. It is suggested to use frequently the
vacuum.
The blowing function is recommended for the ironing of delicate and light garments
because it allows to lift them from the board and to iron them only with the steam
without the pressure of the iron.
7.
GOOD FUNCTIONING
T250P was designed and manufactured for the ironing of domestic garments.
It can be used maximum 20 hrs. per week (subdivided in many times) or 80 hrs. per
month.
8.
INTERVENTIONS AND SMALL REPAIRS
1.
It is recommended to replace the cover (Prontotop) every 400 hrs. or maximum 6
months. Replace it also if the vacuum of the board is unsatisfactory or if stains
appear on it. This operation must be carried out with the switched off and cold
machine. Stains may appear if too much steam is used and/or if vacuum function
is not used enough (in this case reduce steam flow and use more vacuum).
N.B.:
the Prontotop can be washed 1-2 times.
2.
Replace the electric wire immediately when it is damaged. The wire is supplied by
the manufacturer or authorized service centres.
9.
CLOSING OF THE IRONING BOARD
Before closing the table, disconnect the plug and make sure the board is cold.
Proceed as follows:
1.
remove the linen support and put it into the special holes (fig. 1);
2.
pull the
“
hook
”
towards the direction indicated by the arrow and with the other
hand accompany the board till it stops (fig. 2);
3.
unhook the cable support (if supplied) and put it in the special hole (fig. 1-3);
4.
rotate the iron rest panel towards the internal part of the table (fig. 3).
In order to displace the table, seize it at points A & B and incline it slightly so that the
wheels touch the floor (fig. 3).
