Vaporbaby mod. 2010
2
2012
4.
CONNECTION AND STARTING
With VAPORBABY switched off and disconnected plug:
1.
Unscrew the security valve plug (fig. 1), fill the boiler with water (fig. 2) till overflow or at
pleasure (we advise you to use a funnel). Take the plug by the plastic part and screw it again:
do not tighten too much or its gasket might get spoilt.
N.B.
during the filling do not let water to
wash the machine outside; whether it happens, dry it immediately in order to avoid the risk of
electrical discharges.
2.
Insert the plug into a 220 V 16 A socket.
3.
Switch on the boiler (fig. 2 B), the iron (fig. 2 A) and adjust the thermostat (fig. 3)
on “cotton”
(
N.B.
the thermostat of Tulipano irons must be set between “wool” and “cotton”).
4.
Wait for the boiler lamp to switch off (fig. 2 C), the manometer should mark 2,5/3 BAR. At this
point seize the iron by cork handle and press red button 3 or 4 times (fig. 4), so that steam
comes out: this operation must be carried out in order to heat up the tubes which take steam
to iron. In this way you prevent also the falling of small drops of water on garments (iron must
always be held in such a way as not to harm operator, that is with iron always pointed
downwards). To adjust steam flux, you must work on the hand-wheel for steam adjustment
(fig. 2). During ironing operation, the boiler lamp switches on and off (fig. 2 C).
5.
COMPULSORY
1.
Use only normal water coming from the aqueduct.
2.
Never add additives to water.
3.
Empty the boiler only when it is switched off and
cold (the manometer has to indicate 0 BAR). For
carrying out this operation, wear gauntlets against
possible burns.
4.
Never replace the security valve plug (fig. 1)
with other types of plug. N.B. the security
valve plug is set on 4,5 BAR and it has the
function of a security valve.
5.
Connect VAPORBABY to suitable protected socket.
6.
Always keep children away from VAPORBABY, both
when it is on and off.
7.
Do not iron garments directly on persons or things.
8.
Do not empty the boiler during the ironing operation,
wait at least 1 hour after the switching off.
9.
Do not leave hot iron on garments or on the board.
10.
Put the trolley on a steady surface and next to the
ironing board. Do not pull the iron cable too hard or
the trolley might be overturned.
6.
IRONING OPERATION
1.
Run the iron on garments, pressing the iron
microswitch (fig. 4) for steam. For a better result,
set the thermostat (fig. 3
) on “cotton” (between
“wool” and “cotton” for iron mod. Tulipano).
2.
For delicate, blue and black garments, we advise
you to use the anti-sheen shoe.
3.
During ironing operation, always put the iron on its
rubber rest (fig. 1) and pay attention to the position
of the wires: if they twine or get in touch with ironing board, they might cause short circuits.
4.
For dry ironing it is possible to adjust the thermostat (fig. 3) on different positions according to
the type of fabric (look at garment label).
5.
If you work on a non-vacuum board, some circular water spots might form because of
condensed steam. To get round this problem, put a felt under the usual padding and adjust
the hand-wheel for steam regulation on minimum (fig. 2).
TROLLEY
CONNECTION
HAND-WHEEL FOR
STEAM ADJUSTMENT
MANOMETER
WATER FILLING
Fig. 2
