Vaporbaby mod. 2010
3
2012
7.
WATER FILLING
When there is no more water, the lamp “missing water” (fig. 2: D) switches on. So VAPORBABY has
to be switched off by disconnecting plug; rotate the valve plug (fig. 1) of 360° and wait for ste
am to
come out completely (the manometer has to indicate 0 BAR). Unscrew the valve plug with care and
wait some minutes. Then fill the boiler with water till overflow or at pleasure (see point 4.1). Screw
the valve plug again, switch the machine on and wait for the boiler lamp to switch off (fig. 2: C).
Now the iron is ready again.
ATTENTION:
VAPORBABY must always be on horizontal position.
8.
BOILER DISCHARGE
Carry out this operation when the machine is off and the plug disconnected.
Unscrew the valve plug and rotate VAPORBABY rightwards so that water and possible impurities come out.
9.
GOOD FUNCTIONING
VAPORBABY was projected for the ironing of domestic garments. It can be used maximum 10 hrs.
per week or 40 hrs. per month (subdivided in many times).
10.
INTERVENTIONS AND SMALL REPAIRS
1.
Empty the boiler every 20 hrs. of ironing.
2.
Replace the gasket of security valve plug (use only original gaskets) every 1200 hrs. of lighting or
maximum 2 years. For carrying out this operation, the machine has to be switched off and cold.
3.
Replace the security valve plug every 2500 hrs. of lighting or maximum 3 years (fig. 1). For
carrying out this operation, the machine has to be switched off and cold.
11.
COMPULSORY PERIODICAL MAINTENANCE
(To be carried out exclusively by Assistance Centres or by the Constructor)
It is recommended to replace:
1.
the internal security valve every 1400 hrs. of ironing or maximum 3 years;
2.
the internal thermostat every 1400 hrs. of ironing or maximum 3 years;
3.
steam tube and iron cable once they seem spoilt (fig. 3).
It is recommended also to clean the boiler from limestone every 1400 hrs. of ironing or max. 3 years.
12.
ELECTRICAL RISKS
The following situations are considered dangerous for the operator:
1.
damage of iron cables,
2.
loss of water from iron,
3.
iron overheating,
4.
earth protector switch is activated when turning on the main switch,
5.
using VAPORBABY during thunderstorms,
6.
using VAPORBABY without proper protection for feet (without shoes) or with wet feet,
ELECTRIC
WIRE
STEAM
TUBE
THERMOSTAT
Fig. 3
Fig. 4
