Vaporsprint
13
2016
choose whether to use vacuum or blowing set the switch (fig. 2 A) in the desired
position.
If the switch is in the central position, the fan is excluded. In this case only the
heating of the board will work, to turn off press the switch (fig. 2 B).
Ironing:
1.
Run the iron on garments, pressing the iron micro-switch at intervals (fig. 5) for
steam and the vacuum pedal at the same time. The vacuum avoids the stagnation
of the water in the ironing board and allows to dry the garment.
2.
For delicate, blue and black garments, we suggest to use the specific anti-sheen
shoe.
3.
During ironing, always put the iron on its rubber rest (fig. 1).
4.
For dry ironing it is possible to adjust the thermostat (fig. 4) on different positions
according to the type of fabric (look at garment label). For steam ironing, set the
thermostat on “cotton” or “linen”.
7.
WATER FILLING
When the water in the boiler is finished, the “water missing” pilot lamp switches on
(fig. 2 F). At this point disconnect the plug, rotate the valve plug (fig. 3) of 360° and
wait for steam to go out completely. Unscrew the valve plug with care and wait 5/10
minutes.
Then fill the boiler up to the desired level (fig. 3) paying attention not to overfill it (see
section 4 point 1). Screw the safety valve plug again, connect the plug and wait for the
boiler lamp to switch off (fig. 2 E). Now the iron is ready again.
While refilling the boiler, do not spill water onto the machine. In the event this should
happen, dry immediately in order to avoid electrical risks.
8.
BOILER DISCHARGE
Empty the boiler periodically. Carry out this operation when the ironing board mod.
VAPORSPRINT is turned off, cold and the plug disconnected. Wait at least 1 hour after the
switching off. During this procedure, wear proper gloves in order to avoid accidental
burns.
ELECTRIC
WIRE
THERMOSTAT
MICROSWITCH
FOR IRON
STEAM
HOSE
Fig. 5
Fig. 4
