Page 3
For technical questions, please call 1-888-866-5797.
Item 57710
3. Turn Lift Rod to loosen from Main Shaft then lift the
Tripod to desired height. Once height is achieved,
turn to tighten the Lift Rod and secure in place.
4. If needed, use middle Lever on each
Leg to extend height further.
a. Lift Lever and pull leg section down. The middle
Lever adjusts the middle section of the Leg and
the lower Lever adjusts the lower section.
b. Once height is achieved, close Lever
to lock in place securely.
Lift Lever
to open
Push Lever
to close
5. Make sure that the Lift Rod and Levers on each Leg
are securely locked, and that the Tripod is level.
6. Before attaching the Laser Level, check that its
thread size matches the Platform’s screw size.
7. Connect Laser Level to Platform by pulling the
Spring Latch open and removing the Mounting Plate.
Platform
Spring
Latch
open
Spring
Latch
closed
Mounting
Plate
8. Attach Laser Level to Mounting Plate
by screwing it in fully to secure.
9. Reattach Mounting Plate to the Platform.
a. Pull open the Spring Latch and
insert the Mounting Plate.
b. Make sure the Mounting Plate is fully
inserted and lies flat in the Platform.
c. Release the Spring Latch and be sure it closes
fully to secure the Mounting Plate in place.
10. If the height of the Platform needs to be adjusted,
first grasp the Handle to support the Tripod.
a. Turn Set Knob to loosed and then rotate
Crank to adjust the Platform’s height.
b. When desired height is achieved, turn Set Knob
to tighten securely and then release Handle.
Crank
Set Knob
Handle
Platform
Maintenance and Servicing
Procedures not specifically explained in this manual must be performed only by a qualified
technician.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE: Do not use damaged equipment. If abnormal noise
or vibration occurs, have the problem corrected before further use.
1.
BEFORE EACH USE,
inspect the general
condition of the Tripod. Check for loose
hardware, misalignment or binding of moving
parts, cracked or broken parts, and any other
condition that may affect its safe operation.
2.
AFTER USE,
wipe external surfaces of the tool with
clean cloth. Do not immerse the Tripod in any liquids.
3. Store Tripod indoors and out of children’s reach.
