Page 8
For technical questions, please call 1-888-866-5797.
Item 64582
Sa
FE
ty
Op
Era
ti
O
n
Maint
Enanc
E
SE
tup
Operating instructions
read the EntirE iMpOrtant SaFEty inFOrMatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
tool Set up
tO prEVEnt SEriOuS inJury FrOM acciDEntaL OpEratiOn:
Make sure that the trigger is in the off-position and remove its Battery
pack before performing any procedure in this section.
Battery charging
Charge battery after unpacking and before using this
tool. Follow instructions included with battery charger.
Drill Bit installation
cautiOn!
Wear heavy-duty work gloves
to provide protection when inserting and
removing drill bits. Drill bits become very hot during
use. Do not remove drill bit until the bit has cooled.
cautiOn!
Remove the Battery Pack
before changing the drill or screw bit to
avoid unintentional starting of the tool.
1. This drill has a keyless Chuck so no key
is needed to lock the tool bit in place.
2. Only use bits that can be securely fastened in the
Chuck and are designed for the workpiece type.
3. Place bit in the drill, inside the Chuck’s jaws:
a. Open the jaws of the Chuck by holding
the lower ring of the Chuck and turning
the Locking Ring counterclockwise.
b. Open the Chuck jaws until the
bit inserts all the way in.
c. Hold the lower ring and turn the Locking
Ring clockwise to firmly tighten.
d. Make sure the bit is straight and
centered between the Chuck’s jaws.
nOticE: use sharp bits. Dull, bent, or
damaged bits may cause binding and
put stress on the drill and/or bit.
