Page 6
For technical questions, please call 1-888-866-5797.
Item 58671
SAFETY
OPERA
TION
MAINTENANCE
SETUP
Assembly
1. Insert Handle into Spray Wand.
2. Slide Nut onto threaded coupling and hand
tighten securely. Make sure Spray Wand and
Handle are securely connected. See Figure A.
Handle
Spray Wand
Threaded Coupling
Nut
Figure A: Spray Wand and Handle Attachment
3. Attach Nozzle by threading it onto the
Elbow. Make sure connection is secure.
Do not overtighten. See Figure B.
Nozzle
Spray
Wand
Nut
Trigger
Elbow
Elbow
Spray
Wand
Figure B: Elbow Attachment
Note:
If necessary, loosen Nut holding the Spray Wand
and Handle. Rotate the Wand until it is aligned with the
nozzle pointing downward. Retighten the Nut by hand.
4. The Hose comes pre-assembled to the Handle.
If Hose comes loose, slide Nut on hose away
from Hose end. Insert Hose end into Hose
Connector. Slide Nut over the opening and
Hose End. Hand tighten and make sure all
connections are secure. See Figure C.
Handle
Nut
Hose Connector
Hose
Figure C: Hose Connection
Tool Set Up
Filling the Tank
1. Unscrew and remove Tank Lid.
2. Fill Tank with the desired amount of liquid
to no higher than top of fill line.
3. Replace Lid on Tank. Make sure Lid is
tightened securely before use.
Adjusting the Spray Nozzle
1. Loosen the Nozzle for a stream spray.
2. Tighten the Nozzle for a fan spray.
