Page 14
For technical questions, please call 1-888-866-5797.
Item 58520
RETURNS NOT ACCEPTED & WARRANTY VOID
if Sprayer is not properly cleaned and lubricated immediately after every use.
Clean and lubricate Sprayer immediately to prevent permanent damage.
SAFETY
O
PERA
TION
M
AINTENANCE
SETUP
Accessories and Replacement Parts
Accessories
Accessories are available at Harbor Freight stores and at http://www.harborfreight.com.
Storage Fluid
312 Spray Tip
514 Spray Tip
Cup Liner
Nozzle Guard
Repair and Service Parts
Parts are available by calling 1-888-866-5797 or emailing productsupport@harborfreight.com.
Prime/Spray Valve Repair Kit
Outlet Repair Kit
Cup Support Adaptor
Paint Filter
Air Bleed Valve
User-Maintenance Instructions
After Every Use - Cleaning
WARNING! TO PREVENT SERIOUS INJURY: Only water-based materials or materials with
a minimum flash point of 38°C (100°F) should be used for spraying and cleaning.
Only use
water or mineral spirits for cleaning. Only use water-based or oil-based paint for spraying.
1. Lock Trigger and remove battery.
2. Depressurize Sprayer according to
Depressurize Sprayer on page 10.
WARNING! TO PREVENT SERIOUS INJURY: TO
PREVENT FIRE: When using mineral spirits, use
only conductive metal pails placed on a grounded
(concrete) surface. DO NOT use plastic containers.
3. Designate 1 gallon container for waste.
4. Remove Paint Cup, wipe excess
paint from Paint Cup cover.
5. Pour excess paint back into paint container.
6. Remove used Cup Liner and insert clean Cup Liner.
Note:
Cup Liner may be cleaned and reused.
7. Fill Cup Liner half-full with appropriate solvent.
8. Replace Paint Cup.
9. Open
Air Bleed Valve
, squeeze Liner until
reservoir inside Air Hole is filled with solvent.
10. Close
Air Bleed Valve.
11. Shake Sprayer for 10 seconds.
12. Attach battery and unlock Trigger.
13.
Prime:
a. Open
Prime/Spray Valve.
b. Turn Sprayer upside-down, press
Trigger for 2 seconds.
c. Close
Prime/Spray Valve.
