Page 2
March 23, 2015
Battery Installation:
The
Bauer NE
uses 4 AA batteries for operation. We do not recommend zinc carbon batteries for this
application. Batteries not included.
Fresh batteries should be installed as necessary. Battery Life is highly dependent upon battery quality, usage,
and environment (temperature). Remove batteries if the lock will not be used for extended periods of time.
The following steps are shown on the enclosed Battery Installation schematic.
1.
Loosen (2) 6x32 Captured screws on Battery Compartment Lid. These screws are captured to the
Battery Compartment Lid so they will not fall out.
2.
Install the AA batteries in accordance with the orientation shown in the Battery Compartment. The
batteries will fit tightly. Please verify the batteries are touching the contacts on both sides in the
Battery Compartment.
3.
Install Battery Compartment Lid by aligning the (3) tabs on the lid with the (3) slots on the Inside
Plate Assembly. These tabs act as a hinge for closing the Battery Compartment Lid.
4.
Tighten the (2) 6x32 Captured screws back to attach the Battery Compartment Lid to the Inside
Plate Assembly.
Bauer NE
Operation and Programming Guide:
Description
The
Bauer NE
is a 4 touch pad button programmable deadbolt lock. The 4 buttons are labeled “1|2”, “3|4”,
“5|6”, “7|8”. The button labeled “1|2” is the same button whether the number 1 or 2 is desired. Please note this
handle uses Touch Technology. The buttons are activated by Touch and does not require pressing the
buttons. Touch the button and lift finger from button for proper code entry.
Operation
The
Bauer NE
incorporates proximity sensing to determine when you want to activate the lock. To operate
the lock you first must “wake up” the lock. To “wake up” the lock you must touch the area next to the
buttons. The buttons will illuminate once the Touch Pad is wakened. This indicates that the Touch Pad is
ready for the code to be entered.
Preset Factory Code
The
Bauer NE
has a factory set code of 3,7,1,5 followed by the Enter button. The button
with the symbol is the Enter button, and is required to be touched after the code is entered. The
factory code resets every time the batteries are removed for at least 10 seconds.
Programming New Code
To set a new code, touch and hold the “3|4” button and the Enter Buttons for 2 seconds. The
Bauer NE
will
provide three short beeps, indicating it is ready to accept a new code. Enter the new 4 digit code followed by
the . The
Bauer NE
will provide four short beeps to indicate new code has been entered. The first time
the new 4 digit code is entered there will be a long beep indicating the new code is accepted. The new code
can be entered now and will activate the dead bolt.
To reset the code, remove the batteries for at least 10 seconds. Re-install the batteries; and follow the steps to
Programming New Code
.
BP
BP
