background image

Please read these instructions carefully before starting installation 

and keep in a safe place for future reference. ENSURE the room is 

well heated and ventilated.

 

Check the contents of the pack carefully before installation. Bauhaus will 

not be held responsible for any de-fit / re-fit costs where faulty product 

has been fitted.

If any fault is found with materials or workmanship, it must be reported 

immediately to the manufacturer. Remedial action will be taken, based 

on information received, on condition that: 1. Full details are supplied 

to the manufacturer; 2. The product has not been modified or tampered 

with; 3. The manufacturer is informed of any damage/shortages prior to 

installation. 4. The product has not been installed, or attempts have been 

made to install.
We do not accept responsibility for any problems that may occur through 

incorrect installation.

Advice & Safety

This product should only be installed by a suitably qualified Plumber/

installer. Should the installation be completed by a non-qualified person 

any product guarantee maybe considered invalid. For a claim made under 

our warranty written certification of your installers qualifications can be 

required.

It is advised that all doors and drawers are removed prior to fitting to avoid 

unnecessary damage occurring.
It is recommended that the furniture and accessories are installed after 

tiling, ensuring that the product is installed flat to the tile face and allows 

product to be easily removed if required in the future.
These hints have been prepared for your guidance, you must exercise 

due care at all times.

Please note that some units are heavy. Always take care when lifting, and 

follow health and safety guidelines. It is recommended that 2 people carry 

out the installation of larger basin/vanity units.

Warning!

 Please check for any hidden pipes or electrical cables before 

drilling holes in the floor or walls.

When using power tools always follow the manufacturer’s user 

instructions.

Always use the correct wall fixings for non-solid walls – not supplied.

Important pre-installation notes

The carcass on coloured products is supplied with a protective film. This 

should be removed only after installation is complete. Simply peel off and 

wipe down with a well wrung chamois leather or micro fibre cloth.

To ensure full working use of the drawers we recommend the use of 

Bauhaus basin furniture trap BTR0410W.

Care & Cleaning

Ceramic products should be cleaned regularly with warm soapy water, 

then rinsed with clean water and, if desired, dried and polished with a soft 

cloth. Limescale deposits can be removed using a 50:50 solution of warm 

water and limescale remover and soft clean cloth.
We advise against the practice of leaving strong cleaners or bleach in 

ceramic products overnight this will permanently damage the glazed 

surface.

Use a well wrung chamois leather or micro fibre cloth to clean furniture 

carcasses. 

If any maintenance is required then it must be carried out by a qualified 

Plumber.
The manufacturer reserves the right to make technical modifications 

 

without prior notice.

IMPORTANT - Advice and safety - Please read before installation

Tools & equipment needed:

 Drill, 8mm Suitable drill bit, Phillips screwdriver, Spirit level, Ruler/tape measure, Pencil, 

 

Silicone sealant (clear). 

Fixing Basin to wall option:

 12mm Suitable drill bit, 17mm Spanner.

400 Single Drawer Basin Unit & Basin

600 Single Drawer Basin Unit & Basin

BATHROOM FURNITURE RANGE

ESSENCE

INSTALLATION INSTRUCTIONS 

ES0002SCW

ES6000D

ES0001SCW

ES4000D

x2

x1

x4

x2

x2

Basin Unit

Basin

x2

x1

x4

x2

x2

Basin Unit

Basin

Summary of Contents for ESSENCE 400

Page 1: ...ety guidelines It is recommended that 2 people carry out the installation of larger basin vanity units Warning Please check for any hidden pipes or electrical cables before drilling holes in the floor or walls When using power tools always follow the manufacturer s user instructions Always use the correct wall fixings for non solid walls not supplied Important pre installation notes The carcass on...

Page 2: ...gs supplied 2 Attached to the top of the basin unit using silicone 3 Both options 1 and 2 400 Basin Single Drawer Basin Unit 80mm 155 mm 155 mm 285mm 600 Basin Single Drawer Basin Unit Hanging Basin directly on wall Use the measurements above to position the basin on the wall a Mark the fixing hole positions onto the wall Drill Ø 12mm holes insert the wall plugs and screw in the fixing bolts b Pos...

Page 3: ...can be spaced apart the brackets must fit within that measurement b Mark the bracket fixing holes onto the wall Drill Ø 8mm holes insert the wall plugs and attach the brackets c Important The brackets must be the correct way up as shown Position the unit on the brackets Important If the basin unit and or basin are not fitted level this may result on the basin not draining correctly a c Top b b 175...

Page 4: ... manufacturing process Unlike machine finished products natural clay based products shrink and move during high temperature firing and because it is not possible to control this process absolutely minor variations in the dimensional tolerance form and surface of the finished products will occur Before installing a wooden bathroom into a new property extension or recently plastered room we strongly...

Reviews: