IMPORTANT - Advice and safety - Please read before installation
Tools & equipment needed:
Drill, 8mm Suitable drill bit, Phillips screwdriver, Spirit level, Ruler/tape measure, Pencil,
Silicone sealant (clear).
1200 Single Drawer Wall Console
800 Single Drawer Wall Console
BATHROOM FURNITURE RANGE
SEATTLE
INSTALLATION INSTRUCTIONS
SA1200D
SA8000D
1000 Single Drawer Wall Console
SA1000D
Please read these instructions carefully before starting
installation and keep in a safe place for future reference.
Check the contents of the pack carefully before installation.
Bauhaus will not be held responsible for any de-fit / re-fit costs
where faulty product has been fitted.
If any fault is found with materials or workmanship, it must be
reported immediately to the manufacturer. Remedial action will be
taken, based on information received, on condition that:
1. Full details are supplied to the manufacturer; 2. The product
has not been modified or tampered with; 3. The manufacturer is
informed of any damage/shortages prior to installation.
We do not accept responsibility for any problems that may occur
through incorrect installation.
Advice & Safety
This product should only be installed by a suitably qualified
Plumber/installer. Should the installation be completed by a
non-qualified person any product guarantee maybe considered
invalid. For a claim made under our warranty written certification
of your installers qualifications can be required.
It is advised that all doors and drawers are removed prior to fitting
to avoid unnecessary damage occurring.
Ensure the room is well heated and ventilated.
It is recommended that walls are fully tiled before furniture and
accessory installation. This ensures that the product is installed
flat to the tile face and allows product to be easily removed if
required in the future.
These instructions have been prepared for your guidance, you
must exercise due care at all times.
Please note that some units are heavy. Always take care when
lifting, and follow health and safety guidelines. It is recommended
that 2 people carry out the installation of larger basin/vanity units.
Important pre-installation notes
The Console Units are designed for use with wall mounted or
extended height mixer taps or countertop basins with a tap ledge.
We strongly recommend that twin basin settings are installed
on a sold wall only.
The console units CAN ONLY BE installed using the fitting
brackets supplied.
Warning!
Please check for any hidden pipes or electrical cables
before drilling holes in the floor or walls. When using power tools
always follow the manufacturer’s user instructions.
Care & Cleaning
Clean furniture with warm clean water and microfibre cloth.
Normal domestic cleaners that have no bleach or abrasive
ingredients can be used to remove stubborn marks. Then wipe
with fresh water, removing all traces of the cleaning agent,
to prevent streaks forming and dry the surface with a clean
microfibre cloth.
If any maintenance is required then it must be carried out by a
qualified Plumber.
x6
x1/1
x6
x1/1
x6
x1/1
