3
Step 5
a:
Check the unit is level.
If leveling is required: inside the unit, remove both plastic covers
and use a screwdriver to adjust the hanging position.
b:
To lift or lower the unit adjust the screw shown.
c:
To move the unit closer or further from the wall adjust the
screw shown.
d:
Once the unit is level, adjust the screw shown (both sides) to
pull the unit tight against the wall and to lock it in position.
e:
Re-fit both plastic covers.
a
Step 4
Prepare the unit top for tap/s
and basin/s.
Cut holes where required
using a suitable sized hole
cutter.
Important: ALL
cut edges MUST
be sealed with
water proof
sealant or exterior
wood varnish.
Hole cutter
d
e
b
c
