3
a:
Attach the tap to basin and
carefully bed in the waste
using silicone
only
.
b:
Carefully apply silicone to
the top edges of the unit.
c:
Carefully position the basin
down onto the unit, ensure is
centrally positioned and flush
at the back.
Connect the tap and waste.
Attach door handle:
Attach the handle
to the door front.
Note: Only attach the
handle now if
not changing the opening
side (see below).
Re-fit door:
Reposition both hinges over
the screws on the hinge plates. Pull the
door forward and tighten the screws.
Re-fit the glass shelf.
Re-fit drawer:
Pull out both runners.
1:
Place the drawer onto the runners.
2:
Push in until the drawer ‘clicks’ into
position.
Door Unit
-
440 Door Vanity Unit only
T
o move door up or down:
Loosen
screws shown and move door up or
down to suit. Re-tighten.
To move door in or out:
Loosen screw
shown and move door in or out to suit.
Re-tighten.
To move door left or right:
Loosen
screw shown and move door left or right
to suit. Re-tighten.
a:
Loosen the screw (shown) on both hinges, pull door back
and lift the hinges off the hinge plates.
b:
Remove the hinge
plates (and soft close mechanism).
c:
Re-
fi
t the hinge plates (and soft close mechanism) onto the
opposite side.
d:
Rotate the door.
Reposition both hinges over
the screws on the back plates. Pull door forward and tighten the
screws. Attach the handle to the top set of holes on the door.
Changing door opening side
Hinge adjustment
Step 4
Step 5
Tighten
1
2
‘click’
Loosen
Tighten
Remove
Re-fit
a
d
c
b
a
c
b