3
a:
Attach the tap to basin and
carefully bed in the waste
using silicone
only
.
b:
Carefully apply silicone to
the top edges of the unit.
c:
Carefully position the basin
down onto the unit, ensure it is
centrally positioned and flush
at the back.
Connect the tap and waste.
Apply a bead of silicone to the
join between the basin/unit and
wall, on all 4 sides.
Leave silicone, 24 hours to dry.
Re-fit drawer:
Pull both
drawer runners fully out.
1:
Set the drawer down onto
the runners.
2:
Push the drawer fully in until
it locks (click).
Test to make sure the drawer
operates correctly.
Step 4
a:
Check the unit is level.
If levelling is required, use
a screwdriver to adjust the
hanging position, as follows:
b:
To lift or lower the unit,
adjust the screw shown.
c:
To move the unit closer or
further from the wall, adjust the
screw shown.
c
a
Step 5
a
c
b
ZION wall hung unit DRAWER 3
May 17
b
Note
: Basin waste and taps fittings when over tightened can
create stress within the basin material which may in time
cause the failure of the product. Waste fittings should be
carefully bedded in silicone and the back nut hang tightened
an additional quarter turn using a suitable spanner is sufficient to
create the required waterlight seal. Care should also be taken
when fitting brassware to tap platforms in order to prevent similar
stress related failures.
Step 6
‘click’
2
1
