BAUKER PCT162, Original Instruction Manual

EN-12

2. HAMMER FORCE PRESELECTION (SEE FIG B)

With the knob for hammer-force preselection, it is possible to preselect the required hammer force. 

The required hammer force depends on the length of the staples or nails, and on the strength of the 

material. The optimal hammer force setting is best determined through practical testing. Turn the knob 

clockwise to increase the hammer force and turn it counter-clockwise to reduce the hammer force.

3. ON/OFF SWITCH (SEE FIG. C)

To start the machine, set the On/Off switch(6) to I first.

To switch off the machine, set the On/Off switch(6) to 0.

Warning: Switch off the machine immediately when not in use.

4. TO OPERATE THE STAPLE GUN (SEE FIG D)

Plug mains lead into suitable mains supply.

Place the  contact switch (5) of the staple gun firmly onto the material and depress the trigger (1).

Additional pressure applied to the front of the tool will prevent recoil and increase the force applied to 

the nails or staples. This is especially important for ensuring that the nail or staple is driven the whole 

way into a hard surface. 

Note: 

●  Remove all nails/staples from the magazine after each use.

●  The machine is designed only for intermittent operation and will warm up with 

continues use. The tacking force is reduced as a result of heating up. Therefore, 

allow the machine to cool off after 15 minutes (max) continuous operation.

●  There is a contact switch (5) in your staple gun. The contact switch enables the 

staple gun only to be started on contact with the material surface.

MAINTENANCE

Remove the plug from the socket before carrying out any adjustment, servicing or 
maintenance.

There are no user serviceable parts in your power tool. Never use water or chemical cleaners to clean 

your power tool. Wipe clean with a dry cloth. Always store your power tool in a dry place. Keep the 

motor ventilation slots clean. Keep all working controls free of dust. Occasionally you may see sparks 

through the ventilation slots. This is normal and will not damage your power tool.                                  

If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly 

qualified persons in order to avoid a hazard.