BAUKER PCT162, Original Instruction Manual

EN-13

TROUBLESHOOTING

Problem

Possible cause

solution

1. product does not start

1.1  not connected to power supply

1.2  product no switch on

1.3  power cord or plug is defective

1.4  other electrical defect to the 

product

1.1 connect to power supply

1.2 switch ON

1.3 check by a specialist 

electrician

1.4 check by a specialist 

electrician

2. product does not reach 

full power

2.1 extension cord not suitable for 

operation with the product

2.2 power source has too low 

voltage

2.1 use a proper extension cord

2.2 connect to another power 

source

3. fasteners jam in tool

3.1 wrong size fasteners

3.2 driver channel worn

3.3 bent fasteners

3.4 loose magazine/nose screws

3.5 broken/chipped driver

3.1 use only recommended 

fasteners

3.2 replace nail / staple

3.3 discontinue using these 

fasteners

3.4 tighten all screws

3.5 replace nail / staple

ENVIRONMENTAL PROTECTION

Waste electrical products must not be disposed of with household waste. Please recycle where 
facilities exist. Check with your Local Authority or retailer for recycling advice.