5019 603 33004
D
F
NL
E
P
GR
DK
S
N
FIN
I
GB
Freezer compartment temperature adjustment
The appliance is normally factory set to operate at the recommended temperature of -18°C.
To alter the internal temperature between -16°C and -24°C, proceed as follows:
•
Press button I/a or I/b once to adjust the internal temperature: the digital display shows the
temperature previously set.
•
Each time the button is pressed, the temperature setting is changed by 1°C: the value (between
-16°C and -24°C) flashes on the display.
•
Approximately 5 seconds after the button has been pressed for the last time, the set temperature
is stored, the display stops flashing and the current internal temperature is shown on the display.
Note:
The digital display shows internal temperature values b10°C and -24°C.
In the event of a power failure, selected functions remain stored in the memory.
Fast freezing
The fast freeze function is automatically deactivated after 48 hours.
Alarm signals
Note:
The temperature alarm may activate if the door is left open for a prolonged period of time or following
the introduction of fresh food in the freezer compartment; this temporary rise in temperature does not
affect the storage of already frozen food in any way.
Defrosting
Control panel lock function
This function prevents anyone inadvertently altering operating parameters or switching the appliance
off. To lock the control panel: press button J and then button B and hold down for about 5 seconds,
until the yellow led G lights up. To unlock the control panel, press the same buttons again until the
yellow led G switches off.
Signal
Cause
Solution
Door open alarm
The acoustic alarm is
activated
The door has been left open
for more than 1 minute
Close the door
Temperature
alarm
The acoustic alarm and red
led F are activated
The internal temperature is
above -12°C
Press button E; wait for
the temperature to fall
below -12°C again
Temperature
sensor alarm
The acoustic alarm is
activated and the display
shows “SF”
Temperature sensor fault
Contact After-sales
service
Prolonged power
failure alarm
The acoustic alarm and red
led F are activated; the
display flashes, indicating
the highest temperature
reached following the
power failure.
Prolonged lack of power
supply, causing the internal
temperature to rise to very
high values at which correct
food storage cannot be
guaranteed
Press button E; the
display now indicates
the current internal
temperture.
1. Press the freezer on/off button B
An illuminated dot appears on the digital
display
2. Unplug the appliance or switch off at the
main switch
3. Follow the instructions given in the
instructions booklet
4. Plug in the appliance once again
5. Press the freezer on/off button B.
Follow the steps detailed in “Switching on the
appliance”
6Gb33004.fm5 Page 2 Thursday, January 25, 2001 4:32 PM
