PRODUCT DESCRITPION
Note:
Slight gurgling noises from the refrigerating circuit after the
compressor cuts out are perfectly normal.
4. The indicator lights are off and the product is not
working.
• Is there a power failure?
• Is the plug properly inserted in the socket?
• Is the electrical cable intact?
5. The indicator lights are off and the product is working.
• Contact the After-sales Service.
6. The compressor runs continuously.
• Have hot foods been put in the appliance?
• Has the lid of the appliance been left open for a long time?
• Is the appliance positioned in a very warm room or near heat
sources?
• Has someone activated the "Shopping" function? (green
indicator lamps (
3
) flashing) and/or the Turbo Freeze function
(yellow indicator lamp on)?
7. Too much ice forms on the upper edges.
• Are the defrost water drainage plugs correctly positioned?
• Is the appliance lid properly closed?
• Is the appliance lid seal damaged or deformed? (See section
"Installation")
• Have the 4 protection pieces been removed? (See section
"Installation")
8. Condensation forms on the external walls of the
appliance.
• It is normal for condensation to form under certain atmospheric
conditions (humidity above 85%) or if the appliance is located
in a damp or poorly ventilated room. However, this in no way
affects appliance performance.
9. The layer of ice on the internal walls of the appliance is
not uniform.
• This is perfectly normal.
SAFEGUARDING THE ENVIRONMENT
1. Packing
The packaging material is entirely recyclable, and marked with the
recycling symbol. Follow local regulations for scrapping. Keep the
packaging materials (plastic bags, polystyrene parts, etc.) out of
reach of children, as they are potentially dangerous.
2. Scrapping
The appliance is manufactured using recyclable material.
This appliance is marked according to the European directive
2002/96/EC on Waste Electrical and Electronic Equipment
(WEEE).
By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment and
human health, which could otherwise be caused by inappropriate
waste handling of this product.
The symbol
on the product, or on the documents
accompanying the product, indicates that this appliance may not be
treated as household waste. Instead it shall be handed over to the
applicable collection point for the recycling of electrical and
electronic equipment.
Before scrapping, make the appliance unusable by cutting off the
power cable and removing the doors and shelves so that children
cannot easily climb inside the appliance.
Disposal must be carried out in accordance with local
environmental regulations for waste disposal. Deliver the appliance
immediately to an authorized dump; do not leave it unattended
even for a few days, since it is potentially dangerous for children.
For more detailed information about treatment, recovery and
recycling of this product, please contact your local city office, your
household waste disposal service or the shop where you
purchased the product.
Information:
This appliance does not use CFC. The refrigerant system contains
either R134a (HFC) or R600 (HC). Refer to the rating plate inside
the appliance.
Appliances with Isobutane (R600a): isobutane is a natural gas
without environmental impact, but is flammable. Therefore, make
sure the refrigerant circuit pipes are not damaged.
This product may contain Fluorinated Greenhouse Gases covered
by the Kyoto Protocol; the refrigerant gas is inside a hermetically
sealed system.
Refrigerant gas: R134a has a Global Warming Potential of (GWP)
1300.
Declaration of conformity
• This appliance is intended for storing food and is manufactured
in conformity with European regulation (EC) No. 1935/2004.
• This product has been designed, manufactured and marketed in
compliance with:
- the safety objectives of Low Voltage Directive 2006/95/EC
(replacing 73/23/EEC and subsequent amendments);
- the protection requirements of Directive "EMC" 2004/108/CE.
• The electrical safety of the appliance can only be guaranteed if
the product is connected to an approved earth connection.
AFTER-SALES SERVICE
Before contacting After-Sales Service:
1.
See if you can solve the problem yourself.
2.
Switch the appliance on again to see if the problem has been
solved. If it has not, disconnect the appliance from the
power supply and wait for about an hour before switching
on again.
3.
If the problem persists after this course of action, contact
After-Sales Service.
Specify:
• the nature of the fault,
• the model,
• the service number (the number after the word SERVICE on
the rating plate on the rear of the appliance)
• your full address,
• your telephone number and area code.
