22
Appliance operation guide
Control panel lock
function
•
This function prevents
inadvertent altering of
operating parameters
following accidental contact
with the buttons.
•
Once this function has been
selected, even if a button is
pressed the corresponding
function is not activated.
•
To lock the control panel,
press buttons (
8
) and (
4
)
simultaneously for about 3
seconds until the yellow led
(
7
) lights up.
•
Repeat this procedure to
unlock the control panel:
when the yellow led
switches off, the control
panel is no longer locked.
Alarms
•
Temperature alarm
Indicates that the internal temperature is above -12°C.
The acoustic alarm is activated and the red led (
9
) flashes.
Press button (
8
) to mute the acoustic alarm, then immediately
select the fast freeze function and check for any faults.
•
Prolonged power failure
alarm
Indicates that the internal temperature has risen above -8°C
following a prolonged power failure.
The acoustic alarm is activated, the red led (
9
) flashes and the digital
display (
2
) flashes, showing the highest temperature reached during
the power failure. Press button (
8
); the digital display shows the
current internal temperature.
•
Temperature sensor
alarm
Indicates a temperature sensor malfunction.
The acoustic alarm activates, the red led (
9
) flashes and the digital
display shows
"SF"
. Contact After-sales Service.
NOTE: the temperature alarm may activate following introduction of fresh food;
however this does not affect the storage of already frozen food in any way.
A power failure, on the other hand, may compromise the correct storage of frozen
food; in the event of a power failure, check that food is still thoroughly frozen.
Energy saving tips
•
Do not install the appliance in places exposed to direct sunlight or near heat sources.
•
Do not obstruct the ventilation grille or the air circulation openings.
•
Remove accumulated dust from the rear of the appliance at least once a year.
•
Choose the correct temperature setting.
•
Do not place hot food in the refrigerator.
•
Restrict the number of times you open the lid.
•
Make sure the ice layer does not build up to more than 5-6 mm thick.
•
Select ECONOMY mode when the appliance is only partially filled.
Changing the lid light bulb
•
Unplug the appliance from the mains.
•
Remove the diffuser by following the sequence of steps shown
in the figure.
•
Unscrew the light bulb and replace it with an identical bulb of
the same wattage and voltage.
•
Refit the diffuser and plug in the appliance.
4Gb33000.fm5 Page 22 Wednesday, February 14, 2001 6:18 PM
