21
INSTALLATION
•
Install the appliance away from heat sources. Installation in a
hot environment, direct exposure to the sun or installation
near heat sources (heaters, radiators, cookers) will increase
power consumption and should therefore be avoided.
•
If this is not possible, the following minimum distances must
be respected:
• 30 cm from coal or paraffin stoves;
• 3 cm from electric and/or gas stoves.
•
Fit the spacers (if supplied) on the rear of the condenser
positioned at the back of the appliance (see figure).
•
To optimize appliance efficiency, leave a 5 cm gap above the
appliance and make sure that adjacent kitchen units are
sufficiently distanced to allow air circulation.
•
Install the appliance in a dry, well-ventilated place, and
ensure it is level, using the front adjustment feet if necessary.
•
Clean the interior.
•
Fit the accessories.
Electrical Connection
•
Electrical connections must be made in accordance
with local regulations.
•
Voltage and power consumption are indicated on the rating
plate inside the appliance.
•
Regulations require that the appliance is
earthed.
The manufacturer declines all liability for injury to
persons or animals and for damage to property
resulting from failure to observe the above
procedures and reminders.
•
If the plug and socket are not of the same type, have the
socket replaced by a qualified electrician.
•
Do not use extension leads or adapters.
Disconnecting the appliance
It must be possible to disconnect the appliance by unplugging it
or by means of a two-pole switch fitted upline of the socket.
Summary of Contents for KRA 175 OPTIMA
Page 4: ... ...
