11
INSTALLATION
Install the appliance away from heat sources. Installation in a
hot environment, direct exposure to the sun or installation
near heat sources (heaters, radiators, cookers) will increase
power consumption and should therefore be avoided.
If this is not possible, the following minimum distances must
be respected:
30 cm from coal or paraffin stoves;
3 cm from electric and/or gas stoves.
Install the refrigerator in a dry, well-ventilated place.
Clean the interior (see How to clean and defrost the
freezer).
Fit the accessories.
Electrical Connection
Electrical connections must be made in accordance
with local regulations.
Voltage and power consumption are indicated on the rating
plate inside the appliance.
Regulations require that the appliance is earthed.
The manufacturer declines all liability for injury to
persons or animals and for damage to property
resulting from failure to observe the above procedures
and reminders.
If the plug and socket are not of the same type, have the
socket replaced by a qualified electrician.
Do not use extension leads or adaptors.
Disconnecting the appliance
Electrical disconnection must be possible either by unplugging
the appliance or by means of a double-pole switch located upline
from the socket.
Fit the spacers
(Fig. 1, 2 or 3, depending on the model)
Fig.1
Fig.2
Fig.3
6gb33034.fm Page 11 Thursday, July 25, 2002 11:50 AM
