27
Fault display table
a.
Fault in the water supply
The appliance has no or
insufficient water supply.
For models with a fault display, the
“Tap Off”
display lights up and the
spin speed indication lights flash. If
a digital display is fitted, “H” and
“F” are also displayed alternately.
For models with no fault display,
the washing machine stops in the
appropriate programme step.
Switch the appliance off and pull
out the mains plug.
Check whether:
•
the water tap is fully turned
on, and the water supply
pressure is sufficient
•
the water inlet hose is kinked
•
the water connection mesh
filters are blocked (see “Care
and Maintenance/Filters in
water inlet hoses”)
•
the water supply hose is frozen
up
•
the washing machine has a
safety hose and the safety
valve is open (red indicator in
the safety valve inspection
window); In this case replace it
with a new safety hose
Reconnect the appliance to the
electrical socket.
For models with a fault display,
reselect the desired programme
and start it.
For models without a fault
display continue the programme
by pressing the “On/Off” button
again.
If the fault occurs again, please
contact After Sales Service
(see “After Sales Service”).
b.
Draining fault
Waste water not pumped out.
For models with a fault display, the
spin speed indication lights flash. If
a digital display is fitted, “P” and
“F” are also displayed alternately.
For models with no fault display,
the washing machine stops in the
appropriate programme step.
Switch the appliance off and pull
out the mains plug.
Check whether:
•
the drain hose is kinked
•
The pump or the filter is
blocked (see “Removing the
Filter”)
IMPORTANT:
Before draining,
make sure that the washing
water has cooled down.
•
The water in the drain hose is
frozen
Reconnect the appliance to the
electrical socket.
For models with fault display,
select and start the “Drain/
Cancel” programme.
To rinse the laundry, we then
recommend a short programme
without the addition of
detergent.
For models without a fault
display continue the programme
by pressing the “On/Off” button
again.
If the fault occurs again, please
contact After Sales Service
(see “After Sales Service”).
c.
Fault in an electrical
component
The appliance stops in the middle
of a programme.
For models with a fault display,
the spin speed indication lights
flash. If a digital display is fitted,
“F4” to “F16” are also displayed.
Switch the washing machine off.
First of all select and start the
“Drain/Cancel” programme.
Then select and start the desired
programme again.
Luminous display
Spin speed
lights
Digital display
(if fitted)
Fault description
“Tap off”
flash
“H” and “F”
“Fault in water supply”
-
flash
“P” and “F”
“Draining fault”
-
flash
from “F4” to “F16”
“Fault in an electrical component”
“Water Stop”
flash
“A” and “F”
“Water Stop fault”
