35
Installing the decorative plinth
o
A decorative cover for the base of the appliance can be installed
if you wish however it is not essential. The plinth is for
decorative purposes only and will not affect the refrigerator’s
performance.
o
The plinth should be installed using the 3 screws as shown in the
diagram below:
The water inlet hose and water filter
o
The water pressure should be 2.06 - 6.89 bar / 30-100 psi to
allow the icemaker to operate correctly.
o
Care should be taken to make sure that the water inlet does not
come into contact with any hot surfaces.
o
The water filter only filters the water; it does not eliminate
bacteria or microbes.
o
The water filter life will depend on how often you dispense water
and ice. We recommend that the water filter is replaced at least
every 6 months.
o
IMPORTANT: The water inlet MUST be connected to your cold
water supply.
Summary of Contents for B25SE
Page 2: ...s B25SE Side by side frost free fridge freezer...
Page 43: ......
Page 44: ......
Page 45: ...44 www baumatic co uk...