Installing your fridge freezer
If you need the appliance door to open from the
other side, then please reverse the door before
commencing the installation process. (See
“Reversing the door” section on pages 26 - 28).
1) Mark a measurement of 15 mm from the edge of the furniture door.
You should mark this measurement out at the top and the bottom of
the door.
o
Screw the guides to the side of the appliance door. There will be
one screw hole at the top and bottom of each door, a guide
should be fitted to each one.
o
Open the door of the appliance past 90 degrees and then place
the furniture door against it.
o
Carefully locate a slide into each guide, making sure that the
edge of the slide lines up with the 15 mm marking that you
made previously.
o
Mark the position of the first two screw holes of each slide, as
shown in figure 2. Remove the furniture door from the appliance
door. Making sure that the slide is still on the 15 mm marking,
mark the one remaining screw hole on the left hand side of each
slide.
23
Summary of Contents for BR22.8A
Page 1: ...BR22 8A Built in combi fridge freezer...
Page 32: ...32 32...
