27
Remove the top hinge cover of the refrigerator door. Remove the door
by unscrewing the hinge (the door will now be supported only by the
bottom hinge) and remove the hinge washer.
1)
Unscrew the top strip. Move it over to the opposite side of the
appliance and fasten it.
2)
Unscrew the bottom hinge and washer of the freezer door and
remove the lower door.
3)
Unscrew the top hinge of the freezer door and the bottom hinge of
the refrigerator door.
4)
Remove the corner caps from the door and reposition them (instead
of the corner cap with a hole, insert the one without a hole, and vice
versa).
5)
Take off the washer from the bottom hinge of the freezer door (by
turning it in clockwise). Unscrew the bottom hinge filling plug and
screw in the bottom hinge without a plug.
6)
Insert the filling plug and the washer in the reverse order into the
hole for the bottom hinge on the opposite side of the appliance.
7)
Put the freezer door on the bottom hinge.
8)
Turn the bottom hinge of the refrigerator door by 180 degrees.
Insert the hinge and the washer into the hole of the corner cap on the
freezer door and fasten it. Use the same procedure for the top hinge of
the freezer door and screw it on the opposite side of the upper door.
Put the washer and the upper door on the hinge.
9)
Screw the top hinge of the refrigerator door and replace the cover.
10)
Reposition the slide guides on the opposite sides of both doors.
11)
Plug the remaining holes with the caps provided.
NOTE - After you have reversed the door, check that the magnetic
gasket seals correctly. It must not be creased and must seal all
around the door. In case it does not fit perfectly, pull it out and rotate
for 180 degrees. In certain models it is not possible to replace the
door gasket.
