Baumatic BWE41BL, Instruction Manual

Defrosting  
 

o

Defrosting occurs automatically inside of the wine cooler during 
operation. The defrost water is collected by the evaporating tray 
and evaporates automatically. 

o

The evaporating tray and defrost water drain hole should be 
cleaned periodically. This will prevent water from collecting in 
the bottom of the wine cooler, instead of flowing down the 
defrost drainage channel and drain hole. 

o

You can also pour a small amount of water down the drain hole 
to clean inside of it. 

o

You should be careful to make sure that wine bottles do not 
touch the rear wall of the appliance, as this can interrupt the 
automatic defrosting process and deflect water into the base of 
your wine cooler. 

Installation 

IMPORTANT: Before installation and usage read 
all the instructions and make sure that the 
voltage (V) and the frequency (Hz) indicated on 
the rating plate are exactly the same as the 
voltage and frequency in your home. The rating 
plate can be found on the front left edge of the    

        inside of the wine cooler. 

 
The manufacturer declines all responsibility in the event of the installer 
failing to observe all the accident prevention regulations in force, 
which are necessary for normal use and the regular operation of the 
electric system. 
 
Electrical connection 
 

YOUR WINE COOLER IS INTENDED FOR FITTED AND 
PERMANENT INSTALLATION. 
 
 
 

We recommend that the appliance is connected by a qualified 
electrician, who is a member of the N.I.C.E.I.C. and who will comply 
with the I.E.E. and local regulations. 
 

o

Your wine cooler comes supplied with a 13 amp plug fitted. If in 
future you need to change the fuse in this plug, then a 13 amp 
ASTA approved (BS 1362) fuse must be used. 

17