o
Remove the two screws (3) holding the middle hinge (4) in
place. Remove the middle hinge (4).
o
Lift the lower door off the bottom hinge pin and place it on a
cushioned surface to prevent scratching it.
o
Remove the hinge pin (5) from the bottom right hinge (6) and
move to the bottom left hinge (7).
o
Replace the lower door by locating it onto the bottom left hinge
pin (5).
o
Reverse the direction of the middle hinge (4).
o
While holding the lower door in the closed position, reassemble
the middle hinge (4) onto the middle left hand side using the
two screws (3). DO NOT tighten the screws (3) until the top of
the lower door is level with the counter top.
o
Replace the upper door by locating it onto the left middle hinge
pin (4).
o
While holding the upper door in the closed position, reassemble
the top hinge (2) on to the left hand side using the two screws
(1). DO NOT tighten the screws (1) until the top of the upper
door is level with the counter top.
IMPORTANT: Check that both the upper and lower doors open
and shut correctly after you have completed the door reversal
process.
After the door has been reversed, you should check
the door seal of the fridge and freezer door. Neither
seal should be creased or crushed; otherwise there
will be a gap between it and the inside of the door.
o
The seal must adhere properly all the way around the door.
o
If either seal is not adhering to the cabinet properly, then you
should either:-
1. Use a warm damp cloth and manipulate the seal until it does
adhere to the cabinet properly, all the way around the door.
or
2. Use a hair dryer on its lowest heat setting and lightly heat the
areas of the door seal that are not adhering correctly. The
heat will make the seal more pliable and this will allow you to
manipulate the seal into the correct position.
23
