1
1
Press this switch to turn the power 'ON' or 'OFF'.
Operation and temporary stop is repeated as it is pressed. When you want to change
the
program
operating; Press the 'Start/Pause' button
ᆌ
Select the program that you want to change
ᆌ
Press the
'Start/Pause' button again.
You can select the course you want and each lamp is turned on when that course is selected.
You can select the wash course you want and each lamp is turned on when that course is selected.
You can select the rinse time(s) you want and each lamp is turned on when that course is selected.
You can select the spin speed you want and each lamp is turned on when that course is selected.
It can be used to pre-engage time for wash from 1 hr to 12 hrs.
It
is used to perform the
Rinse and Spin
programs only
.
It you want to open
the
Door inten
tionally
during operation, press the 'Start/Pause' button and
then
press
'Door unlock' button.
T
his
signal:
will appear on PCB board, then you can open Door after
the
Tub
has cooled inside
and
the water has drained away. A
lso
,
no button functions except
the
Power button.
It can be used to adjust water temperature according to
the
types of load to be washed.
As this button is pressed, water temperature is selected by Cold
ᆌ
30°C
ᆌ
40°C
ᆌ
60°C
ᆌ
95°C.
Use this function when you want to pr
event
any accident occurring from handling of
the
washer by a child.
During operation of
the
washer, press 'TEMP' and 'RINSE+SPIN' buttons simultaneously
.
If this mode will be set successfully, CHL and remain time will be shown on PCB board alternately. In Child
Lock mode, no button functions except
the
Power button.
If you want to set this mode, press 'TEMP' and 'RINSE+SPIN' buttons simultaneously
within
3 second
s
.
And if you want to release this mode, press 'TEMP' and 'RINSE+SPIN' buttons simultaneously
within
3 second
s
.
If you want to change to the desire
d
program, while this mode is working;
1. Press 'TEMP' and 'RINSE+SPIN' buttons simultaneously again during 3 second
s
.
2. Press the 'Start/Pause' button.
3. Select the desired program and press the 'Start/Pause' buttom again.
THE FUNCTION OF CONTROL PANEL
(
MEGA10W
)
* The Child Lock mode can be set at any time and it is automatically released when operation errors
happen. Also, this mode works when
the
power is off.
Change
the desired
program
