o
Your appliance should not be located in direct sunlight or exposed to continuous heat or extremes of
temperature (e.g. next to a radiator or boiler). If this is not feasible, then you should install an insulation
plate between the appliance and the adjacent heat source.
o
You should check whether there is an electrical socket available, which will be accessible after your appliance
is installed.
o
Place the appliance flatly and firmly on a solid base. The appliance is fitted with adjustable feet at the front,
which should be used to level off the appliance.
o
Anything positioned above the appliance must be at least 15 cm away to allow sufficient cooling of the
condenser. You must allow a 5 cm gap to the rear and either side of the appliance.
o
If supplied, you should fit two spacers to the back of the cabinet, at the top of the condenser. This will ensure
that the correct distance is maintained at the rear of the appliance.
o
If you are placing another cooling appliance next door to this product, then there must be a gap of at least
2cm between the appliances. This will help to prevent condensation from forming.
o
Be sure to leave enough space for the opening of the door, to avoid damage to the appliance or personal
injury.
Troubleshooting
IMPORTANT: If your fridge with ice box appears not to be operating properly, before
contacting the Baumatic Service Department, please refer to the checklist below.
My fridge with ice box does not appear to be working/there is no power to
my appliance.
o
Check that the plug is fully inserted into the power socket.
o
Check that there is power to your mains supply (e.g. that there hasn’t been a power cut or that the fuse
hasn’t blown).
o
Check that the thermostat has not been turned to the off position.
o
Check that your mains supply voltage, corresponds to the voltage stated on the rating plate of your
appliance.
16
