The
green and yellow wire
must be connected to the terminal
marked “E” (earth), or by the earth symbol, or coloured
green
and yellow
.
o
When the connection is completed, no stray strands or cut wire
should be present. The cord clamp must be secured over the
outer sheath.
Positioning
o
It is advisable that your appliance is only installed in a location
where the ambient temperature of the room, corresponds with
the climate classification that is stated on the rating plate of your
appliance. Your appliance may not function correctly if the
ambient temperature falls outside of the following ranges.
Climate classification Appropriate ambient temperature
SN
+10 to +32 degrees centigrade
N
+16 to +32 degrees centigrade
ST
+18 to +38 degrees centigrade
T
+18 to +43 degrees centigrade
o
Positioning the appliance requires two people in order to avoid
injuries or damage to the appliance.
o
Your appliance should not be located in direct sunlight or
exposed to continuous heat or extremes of temperature (e.g.
next to a radiator or boiler). If this is not feasible, then you
should install an insulation plate between the appliance and the
adjacent heat source.
o
You should check whether there is an electrical socket available,
which will be accessible after your appliance is installed.
21
o
Place the appliance
flatly and firmly on
a solid base. The
appliance is fitted
with adjustable feet
at the front, which
should be used to
level off the
appliance.
Summary of Contents for RETRO2
Page 1: ...RETRO2BL RETRO2IV Fridge freezer...
Page 26: ...26...
Page 27: ...27...
Page 28: ...28 28...
