Demolition Jackhammer
E&OE
© 2019 Baumr-AG
3
General Electrical Safety
•
Inspect electrical equipment, extension
cords, power bars, and electrical fittings for
damage or wear before each use. Repair or
replace damaged equipment immediately.
•
Ensure all power sources conform to
equipment voltage requirements and are
disconnected before connecting or
disconnecting equipment.
•
When wiring electrically powered
equipment, follow all electrical and safety
codes.
•
Wherever possible, use a residual current
device (RCD).
•
High voltage / high current power lines may
be present. Use extreme caution to avoid
contact or interference with power lines.
Electrical shock can be fatal.
General Electrical Safety
•
Electrically grounded equipment must have
an approved cord and plug and be
connected to a grounded electrical outlet.
•
Do NOT bypass the ON/OFF switch and
operate equipment by connecting and
disconnecting the electrical cord.
•
Do NOT use equipment that has exposed
wiring, damaged switches, covers or
guards.
•
Do NOT use electrical equipment in wet
conditions or in damp locations.
•
Do NOT use electrical cords to lift, move or
carry equipment.
•
Do NOT coil or knot electrical cords, and
ensure electrical cords are not trip hazards.
General Service Information
•
The equipment must be serviced or
repaired at authorised service centres by
qualified personnel only.
•
Replacement parts must be original
equipment manufacturer (OEM) to ensure
equipment safety is maintained.
•
Do NOT attempt any maintenance or repair
work not described in this manual.
•
After use, the equipment and components
may still be hot – allow the equipment to
cool and disconnect spark plugs and/or
electrical power sources and/or batteries
from it before adjusting, changing
accessories or performing repair or
maintenance.
•
Do NOT adjust while the equipment is
running.
•
Perform service-related activities in suitable
conditions, such as a workshop.
•
Replace worn, damaged or missing
warning/safety labels immediately.
