Cordless Line Trimmer
7
7. To test if the line is advancing properly, push the button with your thumbs while pulling the wire with your
fingers. The line should advance freely.
Option 1: Accessory Replacement Spool
−
Use replacement spool.
Option 2: Rewinding Spool Using Line
−
Line for your trimmer is available at extra cost from your local dealer or manufacturer. To install line,
follow the steps below:
i.
Insert one end of line into the hole in the spool as shown in FIG. 11, about 3 mm.
ii. Snugly and evenly wind the line onto the spool in the direction of the arrow on the spool (FIG. 11),
until the line builds up to the notches in the spool rim. Do not overfill spool. The spool holds about
6.5m of line.
Charging the Battery
The battery needs to be charged before first use and whenever it fails to produce sufficient power on jobs that
were easily done before. The battery may become warm while charging; this is normal and does not indicate a
problem.
NOTE
: After several charge and discharge cycles, the battery will attain full capacity.
DO NOT CHARGE THE BATTERY AT AMBIENT TEPERATURES BELOW 4ºC OR ABOVE 40ºC.
RECOMMENDED CHARGING TEPERATURES: APPROX. 24ºC.
