Three-phase synchronous motors DSC1-045-100
DSC1-045-100
11/2016
Technical alterations reserved
Baumüller Nürnberg GmbH
5
1.
Three-phase synchronous motors DSC1-045-100
With its DSC 45-100 series, Baumüller is making the torque motor
servo-ready. In developing this series, the focus was on improving
ratings in order to achieve a higher torque density while also
drastically reducing the volume of the unit. The typical servo speed
range of up to 4000 min
-1
is, however, still covered.
The motors feature a smooth housing surface is extremely easy to
mount and offer a high degree of protection.
1.1. General technical data
Version:
IM B5
Horizontal mounting acc. to EN 60034-7
IM V1
Vertical mounting, shaft end at the bottom acc. to EN 60034-
7
IM V3
Vertical mounting, shaft end at the top acc. to EN 60034-7
(Note: In the case of IP64 shaft ends, protection against the
ingress of water and dust must be ensured.)
Degree of protection: IP64
Standard: without shaft seal ring, with opposing plugs fitted
and fully enclosed terminal boxes
IP65
Option: with shaft seal ring, with opposing plugs fitted and
fully enclosed terminal boxes
IP65
Without consideration of shaft bushing with opposing plugs
fitted and fully enclosed terminal boxes
IP67
Without consideration of the shaft bushing for IC410 and IC
3W7, fitted with mating connectors, not for motors with
terminal box
Connection
Main connection
See chapter 3.6, 3.7 and 3.3.10
Encoder connection
The main, encoder and fan connector can optionally be
obtained in the speedtec version
Size 1.5 exclusively in speedtec Version
Brake
Connection in the main connection
Note: If the main connection is speedtec design then all the
other connection sockets will be implemented with speedtec
sockets
Temperature sensor
Standard in the main connection and optional in the encoder
socket
Temperature sensor
PT1000, KTY84
– 130
optional
Linear temperature sensor for the analysis in the controller
Cooling type
IC 410
Size 045-100 surface-cooled without fan
IC 416
Size 056-100 surface-cooled with fan
IC 3W7
Size 071-100 water-cooled machine
Temperature rise
= 105 K
Insulation class F acc. to EN 60034
Environmental
conditions for
running
Class 3K3/3Z12 as per
DIN EN 60721-3-3:1995,
however:
temperature range 0-40 °C
Represents 0 to 40 °C at 5 % to 85 % rel. humidity and an
absolute humidity of 1 g/m³ to 25 g/m³ and an installation
height up to approx. 1,400 m.
Environmental
conditions for
long-term storage
Class 1K2/1M1 DIN
EN 60721-3-1:1995,
however:
temperature range -15-60
°C
Represents -15 to 60 °C at 5 % to 85 % rel. humidity and an
absolute humidity of 1 g/m³ to 25 g/m³;
a
t temperatures below 3 °C you should drain the cooling
water
Summary of Contents for DSC1-045-100 Series
Page 1: ...Appli be in motion Three phase synchronous motors DSC1 045 100 ...
Page 2: ......
Page 115: ......
