TAM 00699
9
DSD2 045
– 132
04/2018
Three-phase synchronous motor
English
Winding insulation (EN 60034-1)
Thermal class F(
Δθ = 105 K)
Ambient temperature
0 °C to+40 °C (standard)
Altitude (EN 60034-1)
≤ 1.000 m above sea level (standard)
Rolling-contact bearings with long-term
grease lubrication:
Standard:
Ball bearing
Option (from shaft height 56): Roller bearing (DE-side)
Calculated bearing life
L
H10
20.000 h (approximate value)
Vibration severity (EN 60034-14)
standard:
level A
on request: level B (only for ball bearings)
True running (DIN 42955)
standard:
N
on request: R (reduced)
Vibration resistant (EN 60068-2-6)
radial:
3 g (10 Hz to 100 Hz) size 45-100
axial:
0,5 g (10 Hz to 100 Hz) size 45-100
radial:
3 g
(10 Hz to 55 Hz) size 132
axial:
1 g
(10 Hz to 55 Hz) size 132
Holding brake
Option
Actual speed value encoder
Standard:
2-pole resolver (higher quality version on
request)
Option:
absolute encoder with Hiperface-port
Option:
absolute encoder with EnDat-port
For further technical data, refer to our technical product list online at: www.baumueller.com in the
download area under Technical documentation. If necessary, you can request the corresponding
documents.
Attention!
If the electric motor supplied is not a standard type as per the technical documentation or if special
contractual arrangements have been made, there may be technical differences to these Commissioning
and Maintenance Instructions. In this case request the related technical supplements.
2.5
Transport, bearing lock, intermediate storage
Water-cooled motors:
To avoid frost damages it must be ensured that there is no coolant in the motor during
the transport or intermediate storage at ambient temperatures < 3 °C. The blowing out
of the cooling water can be made by compressed air.
Transport:
The permitted environmental conditions which affect the motor during the transport
must be taken from DIN EN 60721-3-2 (class 2K2/2M1). Contrary to the DIN, a
reduced temperature range of
– 15 °C to + 60 °C is permitted.
Suitable lifting tackles must be used, e. g. belt webbing, loop belts etc. If provided, the
lifting lugs of the motor can be used for lifting.
The motor connectors are not supposed to be used to secure during transport or as
lifting lugs.
The regulations of the respective countries must be adhered to during transport. Lifting
devices and transport and load suspending devices must comply with the relevant
regulations.
For information on weight of the single motors, please refer to the technical documentation that
accompanies the product.
