Bavis Basic Manual Transaction Drawer 3, Installation And Service Manual

3

9.

Caulk the outside perimeter to make weather tight. 
 

10.

Slide the Counter Top and Red Bin Assembly back into the drawer shell/frame, align the 
Counter Top and reuse the screws and holes to secure it. 
 

11.

Re-install the Back Panel and then test the Drawer and Lock operation. 

Servicing the Inside of the Drawer 

Access to the inside of the drawer is through the inside back panel.  There are two screws that go 
into the bottom of the counter top, and two up into the bottom drawer plate, that hold the back 
panel in place.  There is one screw on each side that fastens the back panel to the vertical sides of 
the drawer frame.  After removing the screws, tilt the bottom of the back panel out, and then 
drop it down to remove, (See Fig. 2).  Reverse this procedure to reinstall the back panel. 

Drawer Bin Removal 

To remove the Red Bin, it is necessary to remove the back panel as stated above, and then 
remove the two bolts and spacers attaching the operator handle.  The bin is then pulled into the 
building to remove it from the drawer assembly. 
  
Reinstalling the drawer is as simple as sliding the drawer back into position and reversing the 
above procedure.

Troubleshooting

Drawer won't work.........

Check for damage to drawer.   

           Is the drawer jammed?  If the drawer is jammed, correct the problem.   

Drawer won't run out... 

Check night latch, set to unlock. 
Check that the customer door latches work freely. 

Drawer won’t close fully… 

Check that night latch is set to unlock. 
Check for damage to drawer. 
Check for object between the sliding bin and the inside back cover. 
Is the drawer jammed?  If the drawer is jammed, correct the problem. 

 
After completing the above, if a problem continues, contact qualified service personnel.