8 FINAL ASSEMBLY AND REVIEW
8.1 Fitting the fascia.
8.1.1
Detach the control knob and control
bezel.
8.1.2
Refit the fascia. The fascia top rear strip
should locate in front of, but touching, the side
extensions of the engine back panel (See
figure 14).
8.1.3
Secure the fascia at the bottom sides
with the two screws previously removed.
8.1.4
Place the control bezel back in position
and secure it to the gas tap bracket with two
screws.
8.1.5
Fit the control knob over the gas tap
spindle.
8.1.6
Make sure that the ceramic fuel effect is not dislodged when refitting the fascia.
8.1.7
Refit the window surround. Slide the surround upward to locate its upper tabs in
the slots underneath the fascia hood. Push the bottom of the surround fully against the
fascia cross panel. Drop the surround down so that the two screw heads at the back of
the surround locate in the keyholes in the cross panel.
8.2 Final review.
8.2.1
Recheck the operation of the fire at all control positions.
8.2.2
Visually inspect the appliance. Clean off any marks incurred during installation.
8.2.3
Advise the customer how to operate the fire.
8.2.4
Explain to the customer that the appliance has a flame failure and spillage
monitoring system. Point out the explanation of this system shown in the owner guide.
Advise that if the fire goes out for any reason, wait at least three minutes before
relighting.
Stress that if the monitoring system repeatedly shuts off the fire, the appliance should be
switched off and a specialist should be consulted.
8.2.5
Advise the user that the window may require cleaning periodically outside and
inside as described in the owner guide. Explain how to remove and replace the window
unit for cleaning the inside of the glass etc.
8.2.6
Advise that the fire may give off a slight odour while new. This is quite normal
and it will disappear after a short period of use.
8.2.7
Advise that any cleaning must only be carried out when the fire is off and cold.
8.2.8
Advise the customer that they should read the owner guide before operating the
fire and always follow the advice in the section headed "Cleaning your fire".
8.2.9
Advise the customer that the appliance will operate to its maximum potential if
Page 22
INSTALLER GUIDE
©
Baxi Heating U.K. Limited 2007.
Figure 14. Fascia location
