9.1 To remove the window unit.
9.1.1
Detach the window surround by sliding it upwards and then swinging the bottom
forwards (See figure 6 in the installation section). Lift and store carefully.
9.1.2
Remove the window unit by removing the screws each side of the window frame
and lifting the unit clear.
9.1.3
Replace in the reverse order. Make sure that the ceramic fuel effect is not
dislodged when refitting.
9.2 To remove the fascia.
See figure 5 in installation section.
9.2.1
Remove the control knob by pulling clear of the gas tap spindle.
9.2.2
Remove the control bezel by unscrewing two screws.
9.2.3
Detach the fascia by removing the screws at the fascia sides.
9.2.4
Spring the bottom corners of the fascia outward and pull the bottom of the fascia
forward to clear the fixing brackets. Lift the fascia upward and forward to clear the top
location.
9.2.5
Replace in the reverse order. Make sure that the fascia top rear strip locates in
front of, but touching, the side extensions of the engine back panel. See figure 14 in the
‘Final assembly and review’ section.
Make sure that the ceramic fuel effect is not dislodged when refitting the fascia.
9.3 To remove the ceramic fuel effect.
9.3.1
Remove the window unit as described in section 9.1
9.3.2
Remove the ceramic fuel effect.
9.2.3
Replace in the reverse order. When replacing, make sure that the ceramic fuel
effect rests on the ledges at the sides of the firebox and that its back face is touching the
horizontal rib at the back of the firebox. See figure12 in the installation section.
9.4 To remove the gas tap.
9.4.1
Remove the fascia as section 9.2 above.
9.4.2
Detach the electrode lead from the pilot unit by pulling the lead down and away
from the electrode situated at the centre rear of the burner.
9.4.3
Disconnect the two pipes linking the upper and lower injectors at the tap end and
loosen their connections at the injector ends. Swing the pipes clear of the tap.
9.4.4
Disconnect the inlet pipe and pilot pipe from the gas tap.
9.4.5
Remove the locknut holding the gas tap to the tap bracket.
9.4.6
Carefully lift the tap clear to allow access to the thermocouple connection.
Disconnect the thermocouple from the tap.
9.4.7
Replace in the reverse order.
Page 24
INSTALLER GUIDE
©
Baxi Heating U.K. Limited 2007.
