Remote Control
Install the batteries into the handset by sliding the battery
cover down on the rear of the handset
If the heater does not respond to the remote control handset
commands, it is likely that the batteries require replacement
Replace the batteries with 2, AAA type
.
For longer battery
life use Alkaline batteries.
Use
•
Ensure the heater is plugged into the wall socket and switched
On
•
Aim the remote control towards the heater
The Tell Tale lamps on the front of the stove confirm the selected function
Flame effect
Press LAMP button
Flame effect illuminates
To switch off, press LAMP
Fan
Press ON OFF button
Fan operates
To switch off press, ON/OFF
Low Heat
(The Fan must be On)
Press ON/OFF button. Press 900/1800W button once
Fan and 900 W heater operates
To switch off, press ON/OFF
High Heat
(
Low Heat must be On)
Press 900/1800W button once
Fan and 1800W heater operates
To switch off, press ON/OFF
Timer
(Heater must be On)
Press Timer repeatedly button until time required is set
Tell Tale light will show set time. I.e. 2+1+0.5 = 3.5 hours.
To cancel, press ON/OFF button. Heater will switch off, or
repeatedly press TIMER button until no time is set
Always disconnect the heater from the electricity supply by removing the 3
pin plug and allowing the heater to cool before undertaking maintenance
or replacing the bulb.
Bulb Replacement
The bulbs fitted to this heater are 230V 25W E14 small Edison screw, clear,
candle bulbs
Due to the indeterminate life span and ease of replacement they are specifically
excluded from the guarantee.
To replace a bulb.
To protect the hearth or soft furnishings we strongly recommend placing a
newspaper on the floor before removing the loose coal from the fuel support.
Remove the loose coal and place on the newspaper. Remove the two Philips
Maintenance
Battery
location
ON/OFF
LAMP
TIMER
900/1800W
5
