at a height of 533-560mm (21 inches - 22 inches)
(See figure 5).
3.
Drill an appropriate size hole in the marked
position.
4.
Insert a wall plug into the drilled hole.
5.
Screw the eyescrew into the wall plug.
6.
Position the heater in front of the fireplace
opening.
7.
At the top of the heater there are four small
holes, two each side of the heater (See figure 6-
Item 1). From the front of the heater, thread about
50mm ( 2 inches) of the steel wire into the inside
small hole on the left side of the heater (See figure
6 - item 2).
8.
Thread the other end of the wire through the
remaining small hole on the left hand
side of the heater. Continue to push the
wire through this hole until there is
only a small loop of wire at the front of
the heater (See figure 6 - item 3).
9.
At the back of the heater there will
be a long piece and a short piece of
wire coming through the two holes.
Hold the short piece and give the long
piece a gentle tug. This will secure the
steel wire. Take the long piece and
thread this through the eyescrew in the
back of the fireplace opening (See
figure 6 - item 4).
10.
From the back of the heater thread
the long piece of steel wire through the
outer small hole on the right hand side
of the heater (See figure 6 - item 5).
11.
Locate the heater in the fireplace
opening, then from the front of the
heater, gently pull the steel wire on the
right hand side to gather up the excess
until the heater is secure. Thread the
wire through the remaining small hole
to lock the wire and heater in place
(See figure 6 - item 6).
Pa ge 9
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2007.
Figure 6. Steel wire fixing (Detail at top of
heater may differ from that shown)
Figure 5. Eyescrew position.
