CERAMIC COAL FUEL EFFECT REFITTING
The ceramic fuel effect may cause staining / discolouration to decorative surfaces. It is
therefore advisable to protest decorative surfaces.
Only the fuel effect parts supplied with this appliance or authorised replacements
must be used. Never add extra ceramic fuel effect pieces above the number stated in
these instructions.
If the fuel effect components are
dislodged or removed, they must be
refitted as follows:
1.
Place the ceramic base coal in the
burner compartment. The bottom rear
face of the coal should rest on the
angled ledge at the back of the burner
tray. The bottom front recess of the
coal base should locate against the
tags at the front of the ceramic
support (See figure 3).
2.
Place the left-hand ceramic front coal in
position in front of the base coal (See figure 4).
3.
Place the right hand ceramic front coal in
position in front of the base coal. This should
overlap the left-hand coal. Push the two sides
together to minimise the gap (See figure 4).
Page 9
OWNER GUIDE
Figure 4. Front coal location
Figure 3. Ceramic base location
