GAS CONSUMPTION
Model 661
Has a maximum natural gas input of 6.0kW (Gross)
Has a maximum natural gas output of 3.1kW
Has a minimum natural gas input of 2.3kW (Gross)
Has a minimum natural gas output of 1.1kW
Model 661 when converted using kit number 0595221
Has a maximum propane gas input of 6.1kW (Gross)
Has a maximum propane gas output of 3.15kW
Has a minimum propane gas input of 3.8kW (Gross)
Has a minimum propane gas output of 1.8kW
OPERATING YOUR FIRE
How to light your fire.
!
The controls are shown in figure 1.
!
Check that the main isolating switch is on.
!
Remove the fire front cover / fire front. The controls are behind this cover.
!
Press the "ON" switch. Within a few seconds, the fan motor should start and a small
light will appear on the control box next to the switches. After a few seconds the light
will go out.
!
Depress the control knob and turn partially to the "PILOT/IGN" position until you
feel some resistance.
!
Keep the knob depressed at this position for a few seconds to allow gas to flow to
the pilot.
!
While keeping the knob depressed, turn to the "PILOT/IGN" position. While
turning, a spark should light the pilot. The pilot flame can be seen through the ceramic
fuel effect at the front left side.
!
Keep the knob depressed at the "PILOT/IGN" position for a further ten seconds
then release it. The pilot flame should stay alight.
Page 6
OWNER GUIDE
PLEASE NOTE
When operating your fire for the first time, some vapours may be given off which may
cause a slight odour and could possibly set off any smoke alarms in the immediate
vicinity. These vapours are quite normal with new appliances. They are totally harmless
and will disappear after a few hours use.
